Concrete Driveway Repair: How to Fix Small Cracks and Holes in 3 Easy Steps

Over time, you will find that your concrete driveway develops small cracks and holes as a result of fluctuating temperatures and the natural aging process. While you may think that repairing this damage will be complicated or expensive, the truth is, you can often repair this damage yourself without spending a small fortune in the process. In fact, by following the instructions outlined below, you will be able to complete these repairs in just three easy steps.

What You Will Need

  • Leaf blower or stiff bristled broom
  • large bucket
  • mixing paddle
  • quick set concrete
  • rubber squeegee with long handle
  • putty knife

Step 1: Clean Damaged Area

Any debris that is allowed to mix with your repair patch could ultimately compromise the strength and longevity of your repairs. Consequently, it is extremely important to ensure that your driveway surface is free of all debris before beginning the repair process. The fastest way to accomplish this task is through the use of a leaf blower. However, if you do not have access to this equipment, you can choose to use a stiff bristle brush to clean debris from in and around the damaged area of your driveway.

In the event that you must use water to wash away any stuck on debris or stubborn stains, be sure to let your driveway dry completely before moving on to the next step.

Step 2: Fill Damaged Areas

Once you have a clean work surface, you will be ready to fill in the cracks and holes in your driveway. To do this, begin by mixing a batch of quick set concrete in a large bucket according to the instructions on the packaging. When you are done, your concrete should be the consistency of a thick pancake batter.

Carefully pour the mixture into each crack until it is filled completely. Using a putty knife, smooth out the top of each repair so that any excess materials are spread evenly over the surrounding area.

Be sure to allow ample time for your concrete to dry before moving on to the final step.

Step 3: Refinish Driveway Surface

In order to ensure the longevity of your repairs and create a uniformed appearance throughout your driveway, you will need to apply a thin layer of concrete to the entire surface of your garage. When mixing this batch of concrete, you will need to ensure that it is much thinner in consistency than the batch used to repair any damage.

Once your concrete is ready, simply pour the concrete over your entire driveway. Using a long handled squeegee, spread the concrete evenly over the driveway's surface. After allowing approximately two days for the concrete to cure completely, your driveway will be ready to resume use.

A Final Thought

While minor concrete repairs can easily be completed on a do-it-yourself basis, the repair process described above is not intended to be used when dealing with more severe damage. If the cracks in your driveway are more than a few inches in width or depth, it is always best to contact a reputable concrete contractor like Robert R. Andreas & Sons Inc. in your local area in order to have the damage assessed and repaired.


Share